| Measuring Range | 0.05-10mg/L Alcohol. |
| Operating Voltage | 5V |
| Usage/ Application | Alcohol detection |
| Detecting Concentration | 0.05-10mg/L Alcohol. |
| AO output | 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V |
| Current Consumption | 150mA |
| Power requirements | 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off) |
| DO output | 0.1 and 5V |
MQ-3 Alcohol Gas Sensor Module:This module is made using Alcohol Gas Sensor MQ3. It is a low cost semiconductor sensor which can detect the presence of alcohol gases at concentrations from 0.05 mg/L to 10 mg/L. The sensitive material used for this sensor is SnO2, whose conductivity is lower in clean air. It's conductivity increases as the concentration of alcohol gases increases. It has high sensitivity to alcohol and has a good resistance to disturbances due to smoke, vapor and gasoline. This module provides both digital and analog outputs. MQ3 alcohol sensor module can be easily interfaced with Microcontrollers, Arduino Boards, Raspberry Pi etc. This alcohol sensor is suitable for detecting alcohol concentration on your breath, just like your common breathalyzer. It has a high sensitivity and fast response time. Sensor provides an analog resistive output based on alcohol concentration. The drive circuit is very simple, all it needs is one resistor. A simple interface could be a 0-3.3V ADC Features
|
|---|
MQ-3 Alcohol Gas Sensor Module:
|
|---|
0 out of 5 (0 reviews)
No reviews yet.
