Vetra LV 401 Instant Adhesive, 20g, Box

Vetra LV-401 is a low viscosity, ethyl cyanoacrylate adhesive, which is suitable for bonding a very wide range of materials where very fast cure speed is required. When a thin layer of Vetra LV-401 is applied between two surfaces, it comes into contact with atmospheric moisture, a rapid polymerization occurs producing the ultimate bond.
 
 Applications
Vetra LV-401 is specially formulated for high strength, general purpose bonding of most of the non-porous substrates like plastics, rubbers, metals and porous substrates like wood, leather etc. It is recommended for use on assemblies with very close fitting parts and smooth, even surfaces. It can also be used as a post-assembly adhesive to wick into parts.
 How to use

Make sure the surfaces to be bonded are clean and dry (preferable to solvent-wipe plastics, glass, and rubber, and to acid-treat metals).

Dispense a drop or drops to one surface only. Apply only enough to leave a thin film after compression.

Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute. 

Wipe off excess adhesive from the top of the container and recap Vetra LV-401 if left uncapped, may deteriorate by contamination from moisture in the air.

Because Vetra LV-401 condenses by polymerization, sometimes whitening will occur on the surface of the container.

  Restriction of usage
It will not bond PTFE, nylon, polypropylene etc.
 Shelf Life
12 months from date of manufacturing. It comes without a warranty as storage condition will affect the shelf life.
 Storage

Keep products in the unopened container in a cool and dry location. Best when stored product in a cool, dry place at temperature 20-25°C. Temperatures less than 2°C can adversely affect product properties. Do Not Freeze.

Keep packing tightly closed until ready for use.

Handling precautions

Material removed from containers may be contaminated during use. Do not pour back any product to the original container. Misuse of product will void all warrantees.

Use with proper ventilation. Avoid contact with skin and eyes.

If contact with skin occurs, rinse with warm water or dissolve gradually with solvent such as acetone. Do not try to remove forcibly.

If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately.

Keep well out of reach of children.

For additional information, please consult material safety data sheet.